1. Unboxing

Unpack the spray gun and make sure that the product has not been damaged during transportation and that all the contents are included the packaging.

2. PRESSURE ADJUSTMENT - DIGITAL

1. Turn the knob counter clockwise to increase pressure.
2. Turn the knob clockwise to decrease pressure.

3. PRESSURE ADJUSTMENT - STANDARD

1. Fully open the Air Adjustment on the Spray gun.
2. While pulling the trigger, use the Air Adjustment of the external pressure regulator to adjust the pressure.

4. WEAR PROTECTIVE GEARS

During all fases of setup and operation procedures, always wear proper body and respiratory protection such as:

Anest Iwata safety glasses, mask and gloves.

5. PREPARE PAINT

1. Prepare and dilute paint corresponding to paints TDS (technical data sheet).
2. Make sure your paint is mixed before using it.
3. Check the correct viscosity of the paint as recommended by the paint manufacturer.
4. Fit the paint filter in the gravity cup.
5. Pour paint into the gravity cup by filtering it by an appropriate strainer to eliminate all impurities.

6. SET-UP PRESSURE

1. Check the functionality of the air filterunit.
2. Fully open the pressure regulator for the spray gun and set the correct air pressure on the gauge of the filter unit.

7. FLUID OUTPUT ADJUSTMENT

While pulling the trigger, make sure the pressure is set correctly on the external air pressure regulator and corresponding to the technical data sheet.

Use the fan pattern adjustment to either achieve a flat or a round fan pattern.

1. To decrease the fluid delivery, turn the fluid output adjustment knob clockwise.
2. To increase the fluid delivery, turn the fluid output adjustment knob counter-clockwise.

8. TEST & SPRAY

1. Set the spray distance from the gun to the workpiece, as near as possible within the range of 100 – 250 mm.
2. Test spray (proceed as recomended by the paint manufacturer)
3. Proceed with the painting operations according to the manufacturer’s instructions.